How do you replace the brake cable on the Trionic Veloped?

Question

How do you replace the brake cable on the Trionic Veloped?

Written by Johan Kuikka, Co-founder, Trionic Sverige AB · Last Updated Jul 29 2026

Was this helpful?
Yes
No

Glad we could help. Thanks for your feedback!

Please give us feedback or ask us over:
0330 828 5869
Chat with us
Mail

Or share your feedback directly:

Thank you! Your feedback has been sent. We'll get back to you soon.

Sorry, there was an error sending your feedback. Please try again.

Accepted Answer

You can replace a worn or stretched brake cable on the Trionic Veloped yourself: loosen the handlebar on one side, take off the wheel and brake cover, unhook the old cable at both ends, thread the new cable through the brake lever and brake, refit the wheel, then test and fine-tune the brake with an 8 mm wrench. The video and full steps are below.

Video showing how you replace the brake cable:

Walker/Rollator Brake Cable Replacement video.

loosen the screw on the handle
loosen the screw on the brake lever
open the screws that hold the handlebar (Easiest to change on one side at a time)
pull the grab bar forward on the side you loosened and then pull off the handle and brake lever
remove the wheel
remove the brake cover
remove the wire from the brake
remove the wire from the brake lever
Mount the wire on the brake handle and thread on the brake handle on the handlebar, and press the handle and attach it to the frame
mount the wire in the brake and then mount on the brake protection cover
attach the wheel
Attach the handle and brake lever
test the brake and adjust it if necessary, this is done on the part that protrudes from the brake cover. Screw on it with an 8mm wrench to the desired result